Hanna-instruments HI 9829 Manuel d'utilisateur télécharger pdf (Page 9)

Chapter 2 - QUICK START

Before you begin using the

HI 9829HI 9829

HI 9829 multiparameter system, either charge the

included rechargeable C batteries for at least 6 hours or replace the rechargeable

batteries with non-rechargeable alkaline batteries.

2.1 SENSOR AND PROBE INSTALLATION

• Sensor o-rings must be lubricated with the supplied grease prior to

installation.

• HI 76x9829 probes have 3 sensor connectors identified with color-

coded triangles:

• Connector 1 (red): For either pH/ORP, pH, ammonium, chloride or

nitrate sensor

• Connector 2 (white): For dissolved oxygen sensor

• Connector 3: (blue): For either EC or EC/turbidity sensor

• Position the connector key towards the center of the probe, make sure

the connector is seated correctly (the sensor will no longer move freely)

before tightening the locking threads.

• To protect the sensors, screw the protective shield onto the probe body.

• Unscrew the battery cover of the HI 7629829 logging probe and install

4 AA batteries for autonomous logging before connecting to the meter.

• With the meter off, connect the probe to the DIN socket on the bottom

of the meter. Align the pins and key then push the plug into the socket

and tighten the thread.

• Turn the meter on by pressing the ON/OFF key. The meter will

automatically recognize the probe and the installed sensors and identify

them on the probe status screen.

• Press <Measure> to view the measurement screen.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 103 104

Pas de commentaire

Hanna-instruments HI 9829 Manuel d'utilisateur Page 9