Hanna-instruments HI 9829 Manuel d'utilisateur Page 41
- Page / 104
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
41
7.3 ISE CALIBRATION
From the “Calibration” menu select “Single
param. calibration” and then “ISE calibration”. The
display shows two options: “Calibrate ISE” and
“Restore factory calib”.
When an ISE replaces a pH sensor or another ISE
model, previous calibrations need to be
cleared using the <Restore factory calib.>
option first.
If “Calibrate ISE” is selected, the user can perform a single (10 ppm) or 2 point
calibration with standard 10 ppm and 100 ppm solutions.
If “Restore Factory Calib” is selected, all user calibration data will be deleted and
the default calibration is restored.
NotesNotes
NotesNotes
Notes The ppm tag will blink when a user calibration was not performed.
When a 2-point calibration is performed, all of the old data is overwritten, whereas
for a single point calibration the meter will also use information from the previous
calibration.
7.3.1 Preparation
Prepackaged standards are available in single use sachets. Rinse the ISE with
water and shake off excess water. The procedure always uses 10 ppm first.
7.3.2 Procedure
Cut open the 10 ppm sachet and pour a small quantity of standard over the ISE
tip to rinse the sensor. This should be done over a waste container. Immerse the
ISE sensor and temperature probe into the standard. Position the sachet to
ensure sensor membrane and ceramic junction are completely covered with
solution.
The current measurement or dashes,
temperature, the standard value and the “Not
ready” message are displayed.
• Once the ISE has stabilized the countdown
timer will count down until the display shows
the “Ready” message.
• Press <Confirm> to accept the calibration
point.
• After the first calibration point is confirmed,
remove sensor from sachet packet and shake
standard off. Blot excess with a soft tissue. Cut
open the 100 ppm sachet. Immerse the ISE
sensor and temperature probe into the
standard.
- Multiparameter Meter 1
- HANNA instruments 3
- TABLE OF CONTENTS 4
- Chapter 1 - INTRODUCTION 6
- Chapter 2 - QUICK START 9
- Chapter 3 - SPECIFICATIONS 12
- 3.2 PROBE SPECIFICATIONS 17
- LOGGING PROBE BATTERY LIFE* 17
- 3.3 SENSOR SPECIFICATIONS 18
- 5.4 SETUP MENU STRUCTURE 30
- Chapter 7 - CALIBRATION MODE 35
- Chapter 8 - SYSTEM SETUP 53
- Chapter 10 - STATUS 59
- Chapter 11 - LOGGING MODE 64
- Meter to PC data 75
- Probe Info Screen 77
- Lot Data Screen 77
- If any deposit scales the 82
- APPENDIX B - PROBE DEPLOYMENT 84
- APPENDIX C - ISE INFORMATION 89
- APPENDIX D - ACCESSORIES 95
- APPENDIX E - WARRANTY 101
- Notes:Notes: 102
- Printed in EUROPE 104
- (ROMANIA) 104
Produits connexes et manuels pour Instruments de mesure Hanna-instruments HI 9829
(64 pages)Craftsman 171.240300 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Kreissägen Craftsman 171.240300.
Wir stellen 1 PDF-Handbücher Craftsman 171.240300 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Betriebsanleitung
Commentaires sur ces manuels