Hanna-instruments HI 904 Manuel d'utilisateur télécharger pdf (Page 32)

2-10

SETUP

2.3.4.3.1

Titration Vessel Components

Warning: Always apply a thin layer of joint grease (supplied) to ground-glass joints before

attaching. Improperly-greased joints may become permanently seized!

To assemble the titration vessel, see Figure 4 and follow the steps below:

Karl Fischer Detector Electrode

The Karl Fischer detector electrode (F) consists of two parallel, platinum pins sealed into a

10mm diameter glass body. Two steel pins connect the platinum elements to a standard BNC

connector, which allows for easy attachment to the HI 904.

Attach to the titration vessel (A) in the dedicated ground-glass port.

Karl Fischer Generator Electrode

The Karl Fischer generator electrode (D) consists of two platinum electrodes (anode and

cathode) on a glass body. The anode and cathode may be separated by a diaphragm that is

built into the body of the generator. The HI 904 can be used with both diaphragm and

diaphragm-less generators.

Attach the generator electrode (D) to the titration vessel (A) in the dedicated ground-glass

port.

Desiccant Cartridge

The desiccant cartridge (E) provides a dry path for pressure equalization between the ambient

air and the inside of the titration vessel.

Attach the desiccant cartridge (E) to the top of the generator electrode (D) in the dedicated

ground-glass port.

Figure 4

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 179 180

Pas de commentaire

Hanna-instruments HI 904 Manuel d'utilisateur Page 32