Hanna-instruments HI 120 Manuel d'utilisateur télécharger pdf (Page 7)

HI 120

MAIN KEYBOARD ON THE RIGHT

1) CAL key, to enter and exit/escape calibration mode.

SET key (second function), to enter/exit SETUP mode.

2) CFM key, to confirm different values.

GLP key (second function), to display Good Laboratory Practice Information.

3) CLR key, to clear calibration or logged data.

4) key, to manually increase temperature value or other parameters.

AutoHOLD key (second function), to freeze the first stable reading on

the LCD.

5) key, to manually decrease temperature value or other parameters.

AutoLOG key (second function), to start/stop AutoLOG mode.

6) MODE key, to select the measurement unit or to switch focused data.

7) 2nd key, to select second key function.

8) LOG key, to store measured data.

9) RCL key, to enter/exit view logged data mode.

Note: To select second key function, press 2nd and then the desired key.

The “2nd” tag will appear on the LCD until the desired key is

pressed. To leave second key function selection, press 2nd again.

Calibration Check

RCL

LOG

MODE

CLR

CFMCAL

pH / mV Meter

HI 120

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

Pas de commentaire

Hanna-instruments HI 120 Manuel d'utilisateur Page 7